Porter-Cable D24938-044-2 instruction manual To Assemble Wheels, Assemble Rubber Feet

Page 10

6.If the handle has excessive movement, it is improperly installed. Check the following.

A.Are both tabs inside the handle (Step #3)?

B.Does each clip pass through both the saddle and handle (Step #4)?

To Assemble Wheels

It will be necessary to brace or support one side of the unit when installing

the wheels because the compressor will have a tendency to tip.

1.Attach wheels with shoulder bolts and nuts as shown.

Wheel

Nut

Shoulder Bolt

2.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.

The wheels and handle do not

provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.

Assemble Rubber Feet

1.Attach rubber feet with the screws, washers, and nuts provided as shown.

2.Tighten securely.

Nut

Flat

Washer

Rubber Foot

Screw

D24938

10- ENG

Image 10
Contents Instruction Safety Guidelines Definitions Important Safety InstructionsHazard Attachments & Accessories Electricity. Like any other electrically Result in serious burns Fire, Inhalation, Damage to Vehicle Surfaces Glossary SpecificationsAccessories Duty CycleTo Install Handle AssemblyTools Required for Assembly UnpackingTo Assemble Wheels Assemble Rubber FeetTo Add Oil To Pump Installation Location of the Air CompressorVoltage and Circuit Protection Extension Cords120/240 Dual Voltage Motor Know Your Air Compressor OperationDescription of Operation How to Use Your Unit Before StartingHow to Start Before Each Start-UpMaintenance Customer ResponsibilitiesChecking ChangingAir Filter Inspection and Replacement To Replace BeltMotor Pulley/Flywheel Alignment Service and Adjustments To Replace or Clean Check ValveTo Replace Regulator Storage Troubleshooting Problem Cause CorrectionWhile accessory is being Problem Cause Correction Problem Cause Correction Limited Warranty