Porter-Cable D24938-044-2 Tools Required for Assembly, Unpacking, To Install Handle

Page 9

ASSEMBLY

Tools Required for Assembly

1 - 9/16" socket or open end wrench

1 - 1/2" socket or open end wrench

Unpacking

1.Remove unit from carton and discard all packaging. NOTE: Save all parts bags.

To Install Handle

The wheels and handle do not

provide adequate clearance, stability, or support for pulling the unit up and down stairs or steps. The unit must be lifted or pushed up a ramp. Do not lift the unit by the manifold assembly, the unit could be damaged.

1.To make installation easier, submerge handle grip into warm soapy water. Remove handle grip from soapy water and slide onto handle.

2.Insert the open end of the handle under the saddle. Before attaching handle, you may have to pull the open ends of the handle apart so they fit tightly against the side of the saddle. Looking in from the open end of the saddle, position the handle toward the two bent tabs, on the inside walls of the saddle.

3.Slowly push the open ends of the handle onto both tabs at the same time. Continue pushing the handle into the saddle until the holes on the side of the saddle and handle are in line.

4.Guide the straight end of each retaining clip through the saddle hole and both handle holes.

5.Rotate each retaining clip and press down until it snaps into place over the handle.

9- ENG

D24938

Image 9
Contents Instruction Important Safety Instructions Safety Guidelines DefinitionsHazard Attachments & Accessories Electricity. Like any other electrically Result in serious burns Fire, Inhalation, Damage to Vehicle Surfaces Accessories SpecificationsGlossary Duty CycleTools Required for Assembly AssemblyTo Install Handle UnpackingAssemble Rubber Feet To Assemble WheelsTo Add Oil To Pump Location of the Air Compressor InstallationExtension Cords Voltage and Circuit Protection120/240 Dual Voltage Motor Operation Know Your Air CompressorDescription of Operation Before Starting How to Use Your UnitBefore Each Start-Up How to StartCustomer Responsibilities MaintenanceChanging CheckingTo Replace Belt Air Filter Inspection and ReplacementMotor Pulley/Flywheel Alignment To Replace or Clean Check Valve Service and AdjustmentsTo Replace Regulator Storage Problem Cause Correction TroubleshootingWhile accessory is being Problem Cause Correction Problem Cause Correction Limited Warranty