Risk of Bursting. Too much air
pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.
How to Start:
1.Set the On/Off switch to ON (I) and allow tank pressure to build. Motor will stop when tank pressure reaches
2.Pull the regulator knob out and turn clockwise to increase pressure. When the desired pressure is reached push knob in to lock in place.
The compressor is ready for use.
MAINTENANCE
Customer Responsibilities
| Before | Daily |
| each | or after |
| each | |
| use | |
| use | |
|
| |
Check Safety Valve | ● |
|
|
|
|
Drain Tank |
| ● |
Unit cycles automatically when
power is on. When performing maintenance, you may be exposed to voltage sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.
NOTE: See "Operation" section for the location of controls.
To Check Safety Valve
If the safety valve does not work
properly,
1.Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve
is stuck or does not operate smoothly, it must be replaced with the same type of valve.
13 - ENG | A11894 |