Porter-Cable 4112, 4113, 4114, 4115 instruction manual Routing BOX Joints

Page 12

ROUTING BOX JOINTS

1.Before turning on router, place it on templet and make sure bit will not hit Dovetail Fixture/Jig as it cuts into scrap material.

2.Carefully rout box joints.

3.Loosen front clamp, rotate material as shown in Fig. 21 and position up against templet and edge guide. Clamp securely in place and rout other end.

Fig. 20

Fig. 21

Assemble Box

Fig. 22

12

Image 12

Contents Español Página FrançaiseSafety Guidelines Definitions Important Safety InstructionsAdditional Safety Rules Replacement PartsForeword CapacityAssembly and Adjustment Adjusting Templet LocationAdjusting Edge Guide Location Identifying Drawer Parts HALF-BLIND Dovetails Preparing RouterClamping Drawer Parts Routing Dovetails Inside Half-Blind Dovetails 1/4 HALF-BLIND Rabbeted Dovetails Preparing Drawer FrontClamping Drawer Parts and Routing Dovetails BOX Joints Clamping BOX PartsRouting BOX Joints Maintenance AccessoriesPORTER-CABLE Limited ONE Year Warranty Canadian PORTER-CABLE Delta Service Centers Arizona Illinois Minnesota