Porter-Cable 3802L Moving Cuttinghead to the UP Position, Moving Table to the 0 CUT-OFF Position

Page 8

MOVING CUTTINGHEAD TO THE UP POSITION

1.Pull out the cuttinghead lockpin (A) Fig. 4, and move the cuttinghead (B) to the up position.

2.Fig. 5 illustrates the lockpin (A) pulled out and the cuttinghead (B) in the up position.

B

A

B

A

Fig. 4

Fig. 5

MOVING TABLE TO THE 0° CUT-OFF POSITION

1.Rotate locking knob (A) Fig. 6 counter-clockwise as far as it will go. Depress the lever (B) and rotate the table (C) to the 0° straight cut-off position, release the lever (B), and tighten the locking knob (A).

2.Fig. 7 illustrates the table (C) in the 0° straight cut-off position.

3.For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER CUTTING”, and

“ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.”

C

A

B

C

Fig. 6

Fig. 7

ATTACHING EXTENSION TABLE AND FENCE SLIDE

1.Attach flat washers to the two 5/16-18 x 3/4” screws (A) Fig. 8. Thread the screws into the holes on left side of the saw (Figs. 8 & 9).

NOTE: Turn the screws only a few threads for further adjustment.

2.Attach the table extension (B) Figs. 8 and 9 to left side of saw table, making sure that the groove of the table extension

(B)is inside the flat washers (C) Fig. 8.

3.Use a straight edge (C) Fig. 10 to ensure that the extension table (B) is even with the saw table (D). Tighten the two screws

(C)Fig. 9.

A

B

Fig. 8

B

C

Fig. 9

8

Image 8
Contents Manual Español Página FrançaiseTable of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsAdditional Safety Rules for Miter Saws Additional Safety Rules for the LaserPower Connections Functional DescriptionExtension Cords ForewordCarton Contents AssemblyAttaching Extension Table and Fence Slide Moving Cuttinghead to the UP PositionMoving Table to the 0 CUT-OFF Position Attaching Dust BAG Locking Switch in the OFF Position OperationFastening Machine to Supporting Surface Starting and Stopping MachineAdjusting Sliding FIT Between Movable Table and Base Adjusting Fence 90 to BladeTable Hazard Zone Adjusting Sliding FenceTilting Cuttinghead for Bevel Cutting Adjusting Chip Deflector Adjusting 0 and 45 Bevel Positive StopsAdjusting Sliding FIT Between Trunnion and Bevel Bracket Adjusting the Tension of Cuttinghead Return SpringAdjusting Sliding FIT Between Cuttinghead ARM and Trunnion Adjusting Downward Travel of SAW BladeAdjusting the Dual Laserloc Lines HOW to Check Laser AlignmentHOW the Lasers Work To Check for Rotational AlignmentDual Laserloc Maintenance To Check for Vertical AlignmentAdjusting Lower Blade Guard Typical Operations and Helpful HintsAuxiliary Wood Fence Cutting AluminumCutting Bowed Material Work Support Extensions TroubleshootingCrown Moulding Other Angles Changing the Blade MaintenanceBrush Inspection and Replacement Service AccessoriesWarranty PORTER-CABLE Limited ONE Year WarrantyCanadian PORTER-CABLE Delta Service Centers