ADJUSTING THE DUAL LASERLOC™ LINES
Each of the laser lines have been aligned parallel to the blade at the factory and should not need any adjustment prior to use. However,
HOW THE LASERS WORK
The laser units are mounted in a housing that is fitted into the upper blade guard of the miter saw (Fig. A). The laser units are aligned to the original equipment blade at the factory and are secured in place. A test cut has been made with each saw to verify laser setup. If your saw becomes misaligned or you desire additional precision, this guide is intended to assist you in fine tuning your laser miter saw.
HOW TO CHECK LASER ALIGNMENT
Make sure the saw is set to 0 degrees, miter and bevel, and clamp a 2"x 6" board on the saw. Create a partial test cut in the workpiece (Fig. C). Turn the laser “ON/OFF” switch (Fig. B) to the “ON” position. Leave the workpiece clamped in place for the remainder of the adjustment.
Observe the laser CAUTION label (L) Fig. B.
Place a padlock (A) Fig. B (with 3/16" shackle) through the hole in the trigger switch and lock to prevent accidental motor startup. This padlock MUST remain in place during the adjustment procedure.
The laser lines are properly positioned when the beams of light fall on the edge of the cut created by the blade (Fig. D).
L
A
Fig. B
PARTIAL 
CUT
Fig. C
Fig. D
VERTICAL |
ALIGNMENT |
SET SCREWS |
BRASS |
HEX |
NUT |
Fig. E |
TO CHECK FOR ROTATIONAL ALIGNMENT
The rotation of the lines is set parallel at the factory and permanently secured. No user adjustment is available for the rotational alignment. Never twist the brass hex nuts in Fig. E.
15