!SAFETY RULES
As with all machines, there is a certain amount of hazard involved with the use of this shaper. Use the machine with the respect and caution demanded where safety precautions are concerned. When normal safety precautions are overlooked or ignored, personal injury to the operator can result.
Read, understand and follow the safety and operating instructions found in this manual. Know the limita- tions and hazards associated with this machine.
Electrical grounding. Make certain that the machine frame is electrically grounded and that a ground lead is included in the incoming electrical service. In cases where a cord and plug are used, make certain that the grounding plug connects to a suitable ground. Follow the grounding procedure indicated in the National Electri- cal Code.
Eye safety. Wear an approved safety shield, goggles, or glasses to protect eyes. (NOTE: Common eye- glasses are only
Personal protection. Before operating the machine, remove tie, rings, watch and other jewelry and roll up sleeves above the elbows. Remove all loose outer clothing and confine long hair. Protective type footwear should be used. Where the noise exceeds the level of exposure allowed in Section 1910.95 of the OSHA Regulations, use hearing protective devices. Do not wear gloves.
Guards. Keep the machine guards in place for every operation for which they can be used. If any guards are removed for maintenance, DO NOT OPERATE the machine until the guards are reinstalled.
Work area. Keep the floor around the machine clean and free of scrap material, saw dust, oil and other liquids to minimize the danger of tripping or slipping. Be sure the table is free of all scrap, foreign material and tools before starting to cut. Make certain the work area is well lighted and that a proper exhaust system is used to minimize dust. Powermatic recommends the use of
Operator position. Maintain a balanced stance and keep your body under control at all times. Do not overreach. Do not stand in line with the work piece and do not allow anyone else to do so. Never climb on or near the machine.
Housekeeping. Before turning on machine, remove all extra equipment such as keys, wrenches, scrap, and cleaning rags away from the saw.
Tool maintenance. Clean and sharp tools give better and safer performance. Dull tools can cause kickback and excessive chatter. Before making a cut, always check the condition and adjustment of the tools. Never use a tool that is not balanced and rated for the selected RPM.
Careless acts. Give the work you are doing your undivided attention. Looking around, carrying on a conversa- tion, and “horseplay” are careless acts that can result in serious injury.
Disconnect machine before performing any service or maintenance or when changing cutters. A machine under repair should be RED TAGGED to show it should not be used until the maintenance is complete.
Hand safety. Keep hands clear of the cutter area. Do not reach past the blade to clear parts or scrap with the saw blade running. Never saw free hand. Avoid awkward operations and hand positions where a sudden slip could cause your hand to contact the blade.
Job completion. If the operator leaves the machine area for any reason, he should turn “off” the power to the machine and wait until the cutter comes to a complete stop before his departure. In addition, if the operation is complete, he should clean the table and cutter area. Never clean off the machine with power “on” and never use the hands to clear sawdust and debris; use a brush.
4