Wayne-Dalton 9600, 9400, 9100 Side Lock, Pull Rope, On Doors With Electric, Rope Causing Severe Or

	Side Lock
Tools Needed:	Install the side lock on the second
Power Drill	section of the door. Secure the lock to
	the section with (4) 1/4”- 20 x 11/16”
7/16” Socket	self drilling screws. Square the lock
Driver	assembly with the door section and
Tape Measure	align with the square hole in the vertical
	track. The side lock should be spaced
	in approximately 1/8” from the section
	edge.

	IMPORTANT: side locks must be
	removed or made inoperative in
	the unlocked position if an
	operator is installed on the
	door.	1/8”
	NOTE: After completing this step,
	continue with step 7 on page 12.
		(4) 1/4”- 20 x 11/16”
		self drilling screws
	Pull Rope	NO. 6 SCREW EYE
Tools Needed:	WARNING
Power Drill	DO NOT INSTALL PULL ROPES
	ON DOORS WITH ELECTRIC
1/8” Drill Bit	OPERATORS. CHILDREN MAY
	BECOME ENTANGLED IN THE
	ROPE CAUSING SEVERE OR
	FATAL INJURY.	PULL ROPE
	Measure and mark the jamb
	approximately 48” to 50” (1220 to 1270
	mm) from floor on the right or left side
	of door. Drill 1/8” pilot hole for No. 6
	screw eye. Install the No. 6 screw eye.	PULL ROPE
	Tie the pull rope to the No. 6 screw eye
		BOTTOM
	and to the bottom bracket as shown.	BRACKET
32

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com