|
| 4: Configuration Using |
|
|
|
| |
| Use Hostlist | If this option is set to True, the device server scrolls through | |
|
| the host list until it connects to a device listed in the host list | |
|
| table. Once it connects, the unit stops trying to connect to any | |
|
| others. If this connection fails, the unit continues to scroll | |
|
| through the table until it connects to another IP in the host list. | |
|
| The host list is disabled for Manual Mode and for Modem | |
|
| Mode. The unit will not accept a data connection from a | |
|
| remote device when the host list option is enabled. | |
|
|
| |
| LED | Select Blink for the status LEDs to blink upon connection or | |
|
| None for no LED output. The default setting is Blink. | |
|
|
|
|
Disconnect Mode |
|
| |
|
|
| |
| On Mdm_Ctrl_In Drop | Set to Yes for the network connection to or from the serial port | |
|
| to drop when modem_control_in (DSR) transitions from a | |
|
| high state to a low state. The default setting is No. | |
|
|
| |
| Hard Disconnect | When set to Yes, the TCP connection closes even if the | |
|
| remote site does not acknowledge the disconnect request. | |
|
|
| |
| With EOT | Select Yes to drop the connection when | |
|
| detected. Both Telnet Mode and Disconnect with EOT must | |
|
| be enabled for Disconnect with EOT to function properly. | |
|
| Ctrl+D is only detected going from the serial port to the | |
|
| network. The default setting is No. | |
|
|
| |
| Inactivity Timeout | Use this parameter to set an inactivity timeout. The unit drops | |
|
| the connection if there is no activity on the serial line before | |
|
| the set time expires. Enter time in the format mm:ss, where m | |
|
| is the number of minutes and s is the number of seconds. To | |
|
| disable the inactivity timeout, enter 00:00. | |
|
|
|
|
3.When you are finished, click the OK button.
4.On the main menu, click Apply Settings.
Connection Settings - UDP
To configure a channel’s UDP settings:
1.On the main menu, click Connection. The Connection Settings window for the selected channel displays.
2.In the available fields, enter or modify the following information:
UDS1100 User Guide | 32 |
