Lantronix UDS1100 manual Connection Settings TCP, Flush Input Buffer Serial to Network

		4: Configuration Using Web-Manager
	Match Bytes	Use to indicate the end of a series of data to be sent as one
		group. Set this value to 00 if specific functions are not needed.
	Send Frame Only	After the detection of the byte sequence, indicates whether to
		send the data frame or the entire buffer. Select Yes to send
		only the data frame. The default setting is No.
	Send Trailing Bytes	Select the number of bytes to send after the end-of-sequence
		characters. The default setting is None.
Flush Input Buffer (Serial to Network)
	With Active Connect	Select Yes to clear the input buffer with a connection that is
		initiated from the device to the network. The default setting is
		No.
	With Passive Connect	Select Yes to clear the input buffer with a connection initiated
		from the network to the device. The default setting is No.
	At Time of Disconnect	Select Yes to clear the input buffer when the network
		connection to or from the device is disconnected. The default
		setting is No.
Flush Output Buffer (Network to Serial)
	With Active Connect	Select Yes to clear the output buffer with a connection that is
		initiated from the device to the network. The default setting is
		No.
	With Passive Connect	Select Yes to clear the output buffer with a connection initiated
		from the network to the device. The default setting is No.
	At Time of Disconnect	Select Yes to clear the output buffer when the network
		connection to or from the device is disconnected. The default
		setting is No.

3.When you are finished, click the OK button.

4.On the main menu, click Apply Settings.

Connection Settings - TCP

To configure a channel’s TCP settings:

1.On the main menu, click Connection. The Connection Settings window for the channel displays.

UDS1100 User Guide 29