Lantronix UDS1100 manual Command Command Name Function, Response Meaning

		10: Monitor Mode
	Table 10-1. Monitor Mode Commands
Command	Command Name	Function
VS x.x.x.x	Version	Queries software header record (16 bytes) of unit
		with IP address x.x.x.x.
GC x.x.x.x	Get Configuration	Gets configuration of unit with IP address x.x.x.x as
		hex records (120 bytes).
SC x.x.x.x	Send Configuration	Sets configuration of unit with IP address x.x.x.x
		from hex records.
PI x.x.x.x	Ping	Pings unit with IP address x.x.x.x to check device
		status.
AT	ARP Table	Shows the unit’s ARP table entries.
TT	TCP Connection	Shows all incoming and outgoing TCP connections.
	Table
NC	Network Connection	Shows the unit’s IP configuration.
RS	Reset	Resets the unit’s power.
QU	Quit	Exits diagnostics mode.
G0, G1, ....,Ge, Gf	Get configuration	Gets a memory page of configuration information
	from memory page	from the device.
S0, S1,...,Se, Sf	Set configuration to	Sets a memory page of configuration information
	memory page	on the device.
GM	Get MAC address	Shows the unit's 6-byte MAC address.
SS	Set Security record	Sets the Security record without the encryption key
		and length parameters. The entire record must still
		be written, but the encryption-specific bytes do not
		need to be provided (they can be null since they
		are not overwritten).

Note: Entering any of the commands listed above generates one of the following command response codes:

Table 7-2. Command Response Codes

Response Meaning

0>

1>

2>

8>

9>

OK; no error

No answer from remote device

Cannot reach remote device or no answer

Wrong parameter(s)

Invalid command

UDS1100 User Guide 64