4: Configuration Using Web-Manager
You must configure the unit so it can communicate on a network with your serial device. For example, you must set the way the unit will respond to serial and network traffic, how it will handle serial packets, and when to start or close a connection.
The unit’s configuration is stored in nonvolatile memory and is retained without power. You can change the configuration at any time. The unit performs a reset after you change and store the configuration.
In this chapter, we describe how to configure the UDS1100 using
Note: The examples in this section show a typical device. Your device may have different configuration options.
Accessing UDS1100 Using DeviceInstaller
Note: Make note of the hardware (MAC) address. You will need it to locate the UDS1100 using DeviceInstaller. For more information on the hardware address, see Hardware Address on page 15.
Follow the instructions on the product CD to install and run DeviceInstaller.
1.Click StartÆPrograms Æ LantronixÆDeviceInstallerÆDeviceInstaller. If the PC has more than one network adapter, a message displays requesting the selection of a network adapter. Select an adapter and click OK.
2.Click the Search icon 
. The list of Lantronix device servers displays in the left pane.
3.Click the UDS folder. The list of available UDS products displays.
4.Expand the list of UDS1100s by clicking the + symbol next to the UDS1100 icon.
5.Select the UDS1100 unit by clicking its hardware address.
6.In the right pane, click the Web Configuration tab.
7.To view the UDS1100’s
Note: Alternatively, to open
UDS1100 User Guide | 21 |
