Lantronix UDS1100 manual Channel, Port Settings, Pack Control

4: Configuration Using Web-Manager

Channel 1

Disable Serial Port

When selected, disables communication through the serial port. The serial port is enabled by default.

Note: This feature is not available on single port device servers.

Port Settings

Protocol	From the drop-down menu, select the protocol type for the
	selected channel. The default setting is RS232.
Flow Control	Flow control manages data flow between devices in a network
	to ensure it is processed efficiently. Too much data arriving
	before a device is prepared to manage it causes lost or
	retransmitted data. None is the default.
Baud Rate	The unit and attached serial device, such as a modem, must
	agree on a speed or baud rate to use for the serial connection.
	Valid baud rates are 300, 600, 1200, 2400, 4800, 9600
	(default), 19200, 38400, 57600, 115200, and 230400 baud.
	The default setting is 9600.
Data Bits	Indicates the number of bits in a transmitted data package.
	The default setting is 8.
Parity	Checks for the parity bit. The default setting is None.
Stop Bits	The stop bit follows the data and parity bits in serial
	communication. It indicates the end of transmission. The
	default setting is 1.

Pack Control

Enable Packing	Select to enable packing on the UDS1100.
	Two firmware-selectable packing algorithms define how and
	when packets are sent to the network.
	The standard algorithm is optimized for applications in which
	the unit is used in a local environment, allowing for very small
	delays for single characters, while keeping the packet count
	low.
	The alternate packing algorithm minimizes the packet count
	on the network and is especially useful in applications in a
	routed Wide Area Network (WAN). Adjusting parameters in
	this mode can economize the network data stream.
	Disabled by default.
Idle Gap Time	Select the maximum time for inactivity. The default time is
	12 milliseconds.
Match 2 Byte Sequence	Use to indicate the end of a series of data to be sent as one
	group. The sequence must occur sequentially to indicate end
	of the data collection to the UDS1100. The default setting is
	No.

UDS1100 User Guide 28