Wayne-Dalton 9400, 9100, 9600 TorqueMaster Spring Tube, Center Bracket Bushing

14	TorqueMaster® Spring Tube
Tools Needed:	TorqueMaster® springs come lubricated
None	and pre-assembled inside the
	TorqueMaster® spring tube. To install,
	lay the TorqueMaster® spring tube on
	the floor (inside garage) in front of the
	door with the labeled end to the left.

TorqueMaster®

Spring Tube

LABELED END

15	Center Bracket Bushing	CENTER
		BRACKET
Tools Needed:	NOTE: If you are installing the ® opener	ASSEMBLY
None	with your garage door, skip this step
	and go to your idrive® Installation
	Instructions and Owner’s Manual.
	After completing steps 1-13 of your	TorqueMaster®
	idrive® Insatallation Instructions and
	Owner’s Manual, rear supports will to	Spring Tube
	be fabricated/installed to support the
	horizontal tracks see step 24.
	NOTE: If you are not installing the
	idrive® opener on your garage door, you	TorqueMaster®
	must install the center bracket bushing	Spring Tube
	assembly. Follow these instructions for
	non-idrive®operated garage doors.
	Being cam shaped the center bracket
	bushing only fits one way.
	Slide the center bracket assembly
	towards the center of the	CENTER
	TorqueMaster® spring tube, from the
	right side as shown.	BRACKET
		BUSHING
18

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com