Manuals / Wayne-Dalton / Household Appliance / Garage Door Opener

Wayne-Dalton 9600, 9400, 9100 Securing Door, for Spring Winding, Installation

Models: 9600 9100 9400

1 40

Page 23

	20	Securing Door
	20	for Spring Winding
	Tools Needed:	Place vice clamps onto both vertical
	Vice Clamp	tracks just above the third roller. This is
	Vice Clamp	to prevent the garage door from raising
		to prevent the garage door from raising
		while winding counterbalance springs.

WARNING

Failure to place vice clamps onto vertical Track can allow door to raise and cause severe or fatal injury.

place

vice

clamps

above

3rd

Roller

vice clamps	Track
attached to	Track
inner rail
of track

INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Page 23

Image 23

Wayne-Dalton 9600, 9400, 9100 installation instructions Securing Door, for Spring Winding, Installation

Contents

TorqueMaster Plus - Single and Double Spring 9100, 9400 and 9600 SeriesTable of Contents Definition of key words used in this manualPackage Contents Door Section Identification Removing An Existing Door Tools Requiredsound framing could cause springs to securely attach aFailure to suitable mounting pad to structurallyCutting Vertical Track and InstallationInstalling Q.I. Jamb Brackets INSTALLATIONTools Needed Tape Measure Hacksaw Power Drill Installing Q.I. Jamb Brackets ContinuedAttaching Fully Adjustable Flagangle to Vertical TrackBottom Section Counterbalance DrumsVertical Track INSTALLATION Stacking SectionsTop Brackets INSTALLATION U-BarU-Bar- Asymmetrical U ar Operator BracketINSTALLATION Top SectionDO NOT RAISE DOOR UNTIL Fully Adjustable FlaganglePOSITION CAUSING SEVERE OR Attaching Horizontal Track tohorizontal track Adjusting Top BracketsINSTALLATION the top bracket slide, out against theCenter Bracket Bushing TorqueMaster Spring TubeTHE GARAGE LOOKING OUT Drum WrapsINSTALLATION tube assembly with the tabs facingCable Drums Brackets End BracketsINSTALLATION securely attached to both Endassembly, follow these instructions AssemblySecuring Center Bracket NOTE If you are not installing theINSTALLATION Securing Doorfor Spring Winding cable drum Cable AdjustmentCable must be taut and in the spiral, or thread, of thethe TorqueMaster Plus springs Winding Springsit is recommended that leather gloves be worn while windingresult in door falling and Drum Wrap InstallationWinding Springs Continued raising door further canINSTALLATION Rear Support1. Check the door for level Rear Support ContinuedTools Needed doorsInstructions TorqueMaster Plus ResetATTEMPTING TO RESET THE OF THE PROCEDURES, DO NOTTorqueMaster Plus Reset Instructions ContinuedTools Needed TorqueMaster Plus ResetInstructions Continued Pull Rope ROPE CAUSING SEVERE ORDO NOT INSTALL PULL ROPES Side LockStep Plate optional INSTALLATIONTrolley Installation for Standard Lift optional INSTALLATION Trolley Installation for Low HeadroomFEATURES FUNCTION. FAILURE AT TIME OF INSTALLATIONINSTALLATION INSTRUCTIONS ENSURE THAT DOOR SAFETYPainting Cleaningmaintenance Painting Continued Lifetime Limited Warranty Models Please Do Not Return This Product To The Store Thank you for your purchase