Wayne-Dalton 9600 Winding Springs Continued, raising door further can, result in door falling and

	Winding Springs Continued...	End Bracket
Tools Needed:	IMPORTANT: Mark Number of Spring
	Turns on TorqueMaster® Plus end
	bracket warning tag.
	NOTE: Since total turns to balance door
	can deviate from spring turn chart
	values by ± 1/2 turn, adjustments to the
	recommended number of turns may be
	required after rear hangers assembly is
	completed.
	IMPORTANT: Hold the door down to
	prevent it from rising unexpectedly	Pawl Knob in Lower
	in the event the spring was
			Position
	overwound and cautiously remove
		Back of torquemaster® plus end bracket warning tag
	vice clamps from vertical tracks.
	Do not raise the door until horizontal tracks
	are secured at the rear, as outlined in step
	24.	Spring Turns
	WARNING
		Door Height	Spring Turns
		(6’ - 0”)	14
	raising door further can	(6’ - 3”)	14 - 1/2
		(6’ - 5”)	15
	result in door falling and	(6’ - 6”)	15
	cause severe or fatal injury.	(6’ - 8”)	15 - 1/2
		(6’ - 9”)	15 - 1/2
		(7’ - 0”)	16
		(7’ - 3”)	16 - 1/2
		(7’ - 6”)	17	Location for
		(7’ - 9”)	17 - 1/2	marking number
		(8’ - 0”)	18
				of installed
		Number of Installed Spring Turns		spring turns
23	Drum Wrap Installation	drum wrap
		(left hand)
	Starting with the left hand side, align	drum
None	the counterbalance cable with one of	(left hand)
	the slots in the drum wrap. Slide the
	drum wrap over the drum until the tabs
	snap between the cable drum and the
	ratchet gear. Repeat for right hand side.
	IMPORTANT: Right and Left hand
	are always determined from
	inside the Garage looking out.
		Counterbalance
		cable
			tabs
		groove
		in drum
26

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com