Wayne-Dalton 9600, 9400, 9100 installation instructions Stacking Sections, Installation

6	Stacking Sections
Tools Needed:	NOTE: For door section identification
Power Drill	see page 4.
7/16” Socket	NOTE: Make sure hinge leafs are
Driver	flipped down, when stacking another
	section on top.
	Place rollers in hinge tubes of the
	second section (lock section).
	With assistance, lift the second section
	and guide rollers into the vertical
	tracks.
	Maintaining section vertical alignment;
	starting with the center hinge first,
	flip up the hinge leaf, and hold it tight
	against the section. Secure it to the
	section with (3) 1/4”-14 x 5/8” self
	tapping screws.
	Attach center hinges first, then attach
	the end hinges last.
	Now, secure the end hinge leafs to the
	section with (2) 1/4” -14 x 5/8” self
	tapping screws and fasten them in a
	low to high inclination (from bottom
	left hole, to upper right hole, for the left
	side of the door and from bottom right
	hole, to upper left hole, for the right
	side of the door).
	Repeat for other section(s) except top
	section.
	IMPORTANT: Push & hold the
	hinge leaf against section while
	securing with 1/4”-14 x 5/8” self
	tapping screws. End Hinges have
	(2) screws and Intermediate
	hinges have (3) screws.
	NOTE: Install lock at this time (sold
	separately). See instructions in
	OPTIONAL SIDE LOCK INSTALLATION
	on page 32.

LOCK SECTION

DO NOT USE

(2) 1/4”-14 X 5/8”

SELF TAPPING SCREWS

end hinges (left hand shown, right hinge symmetrically opposite)

(3)1/4”-14 X 5/8” SELF TAPPING SCREWS

INSTALLATION

intermediate hinges

11

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com