Shipping Contents

Unpacking

Remove box and wood crating completely from around saw. Check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Table Saw is assembled and running properly.

Compare the contents of your container with the parts lists on this page and the following page to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

1.Unbolt the saw from the skid.

2.Carefully remove the saw from the pallet and place it in position.

IMPORTANT: The saw is extremely heavy. It is strongly recommended that a sling or hoist system be used to remove the saw from the pallet.

The Table Saw should be placed in an area with a sturdy, level floor, good ventilation and sufficient lighting. Leave enough space around the machine for mounting extension wings and rail assemblies, and loading and off-loading stock and general maintenance work.

Cleaning

Exposed metal surfaces, such as the table top and extension wings, have been given a protective coating at the factory. This should be removed with a soft cloth moistened with kerosene. Do not use acetone, gasoline, or lacquer thinner for this purpose. Do not use solvents on plastic parts, and do not use an abrasive pad because it may scratch the surfaces.

Contents of the Shipping Container

Main Saw Container

1Table Saw (A)

1Table Insert (B)

1Small Box (shown page 8)

The following items are inside the saw:

1Miter Gauge Assembly (C)

1Blade Guard Assembly (D)

1Switch in box (E)

1Owner's Manual (not shown)

1Warranty Card (not shown)