Powermatic PM2000 manual Assembly, Mounting Extension Wings

Page 10

Assembly

Mounting Extension Wings

Referring to Figure 1:

1.Mount a cast iron extension wing (A) to the right or left side of the table (B) using three each 3/8-16x1 hex head screws (C), 3/8 lock washers (D) and 3/8 flat washers (E). Have an assistant hold the extension wing up to the table while inserting the screws and washers. Finger-tighten only.

Note: If an assistant is not available, hold the wing in vertical position up to the saw table, insert the middle screw and lock washer finger tight, then pivot the wing to level position. Insert the other two screws and washers finger tight.

2.Mount the remaining extension wing to the other side of the table in the same manner.

3.Make sure that the front edge of the extension wings are flush with the front edge of saw table (Figure 2).

4.Level the extension wing with the saw table across its entire width (Figure 3) using a straight edge and hammer with block of wood (or rubber hammer).

As each area of the wing becomes flush with the table, tighten the screw under that area. Continue until all three screws are fully tightened.

5.Repeat for the other extension wing.

10

Figure 1

Figure 2

Figure 3

Image 10
Contents Inch Cabinet Saw Warranty and Service Warranty PeriodTable of Contents Page Page Introduction Specifications Shipping Contents Contents of the Shipping Container Extension Tables Assembly Mounting Extension WingsLock Knobs and Swivel Handles Dust ChuteBlade Installation/Replacement Motor CoverRiving Knife and Guard Installation DescriptionGrounding Instructions AdjustmentsHandwheel Adjustments Extension CordsZero-Clearance Insert Setup Castor system adjustmentTilt Stop Adjustment Miter Slot AlignmentPrecision Miter Gauge Drive BeltRiving Knife Adjustment Lateral alignmentInsert Adjustment Arbor and Arbor Bearing RemovalOperating Controls Safety KeyStart/Stop Overview OperationsKickback Rip Sawing Crosscutting Bevel and Miter Operations Do not use the standard table insert for dadoing operationsPush Stick Safety DevicesFeather Board and Push Blocks Filler PieceLubrication MaintenanceMiscellaneous Troubleshooting TroubleOptional Accessories Ordering Replacement PartsModel PM2000 Table Saw Parts List Side Cover AssemblyTable & Cabinet Assembly Retractable caster system, patent US 8,006,596 B2 Trunnion & Motor Assembly Parts List PM2000-MFCB PM2000-288 Trunnion & Motor Assembly Blade Guard & Miter Gauge Assembly Parts List PM2000-AKPABlade Guard & Miter Gauge Assembly Magnetic Switch Wiring DiagramsMotor Electrical Board Motor Page Page New Sanford Road LaVergne, Tennessee Phone
Related manuals
Manual 16 pages 7.52 Kb Manual 9 pages 33.54 Kb