AIR Supply

7.Re-install clear panel and close blade access door, fastening it securely. NOTE: A sensor switch on the door will automatically shut down the saw if the door is opened while the blade is moving.

WARNING: Do not reconnect power, air or electric, without internal clear panel in place and door securely fastened with screws.

The correct air pressure for the COS18 saw is 70 PSI. Attach the hose from your air source to the machine's air valve as shown in Figure 9.

SQUARING THE FENCE

The best way to square the fence is to make sample cuts. Using a square, check the end of a board after it has been chopped. If the cut is not square, proceed as follows:

1.Loosen one of the bolts on the fence and lightly tap the fence with a block or mallet.

2.Retighten the bolt, and make another cut. Repeat as necessary until fence is square.

INSTALLING ROLLER TABLES

(OPTIONAL)

Four-foot and 8-foot roller tables are available as accessories to your cut-off saw. The roller tables can be used as infeed or outfeed tables and mounted to either side of the saw. The terms "Right Hand" and "Left Hand" Model are determined by the location of the blade in reference to the main table. (The cover of this manual shows a left-hand model.)