Foot Table Guide | Powermatic COS18 guide

8-FOOT TABLE GUIDE

1.The 8-foot table comes with a guide and scale. The guide should be mounted to the edge of the table with six M8 x 27 square head bolts, six M8 flat washers and six M8 hex nuts (Fig. 13).

2.Attach the three stops to the 8-foot table guide (Fig. 13). These stops can be slid to any point along the guide and secured by tightening the lock levers.

LEVELING & ALIGNING ROLLER TABLES

Each roller table must now be leveled with the main saw table and aligned with the fence. (The fence must be square with blade – see "Squaring the Fence", page 11.)

WARNING: Disconnect saw from both air and electric power sources.

1.Select a piece of scrap board with a good straight edge, 4 to 6 feet in length.

2.Raise the blade guard and keep it raised. Place the board, straight edge down, on the saw table surface and allow it to extend to the second or third roller of the roller table (Fig. 14).

3.Level the roller table by loosening the hex nut on the foot pad and screw the foot pad in or out. (see Fig. 12).

4.When roller table and main table are level, tighten the nuts on the foot pads.