Powermatic COS18 owner manual To mount roller tables to saw

To mount roller tables to saw:

1.Mount an angle bracket to the pre-drilled holes in the side of the saw cabinet with four M8 x 20 hex cap screws and four M8 flat washers (Fig. 10). Do not fully tighten yet.

2.Place the roller table upside down on a flat surface and attach the leg assemblies with four M8 x 25 hex cap screws, eight M8 flat washers, and four M8 hex nuts per leg assembly (Fig. 11).

3.Screw an adjustable foot pad into each leg as shown in Figure 12.

4.Flip the roller table right-side up and mount it to the angle bracket on the cabinet as shown in Figure 10. Use two M8 x 25 screws, four M8 flat washers and two M8 hex nuts. Do not fully tighten yet.

13