Powermatic PWBS14 operating instructions

Page 13

9.Loosen the nuts on the four motor mounting bolts (Fig. 4), and tension the v-belt by pushing down on the motor. Tighten the four motor mounting nuts.

The v-belt is properly tensioned when finger pressure between the two pulleys causes approximately 1/2" deflection (Fig. 4a).

10.Screw the two small knobs (Fig. 5) into the threaded holes in the saw body. Slide the pulley cover down over the knobs, and tighten the knobs.

11.Attach trunnion support to saw body with two M8 x 30 hex cap screws and two M8 lock washers (A, Fig. 6).

12.Thread nut (B, Fig. 6) onto table stop bolt (C, Fig. 6) and attach to trunnion support as shown.

13

Image 13
Contents Model PWBS14 Woodworking Band SawLimited Warranty Warranty & ServiceMore Information Table of Contents Safety Rules Page Safety Volt Operation Grounding InstructionsDisconnect the machine from the power source Specifications PWBS-14 Band Saw PWBS-14 Band Saw Dimensions Receiving Page Page Page Page Mounting Rails & Rip Fence Page Page Tilting the Table Adjusting 90 Table StopChanging Blades Adjusting Blade Tracking Adjusting Blade TensionAdjusting Upper Blade Guide & Blade Support Bearing Adjusting Upper Blade Guide AssemblyMiter Gauge Adjusting Lower Blade Guide and Blade Support BearingProblem Possible Cause Solution TROUBLE-SHOOTINGPWBS-14 Band SawDescription Size Optional Accessories for PWBS-14 Band SawReplacement Parts & Service Index Part Description Size Qty Parts List Body Assembly PWBS-14 Band SawTS-1551041 131 PWBS14-231 Body Assembly PWBS-14 Band Saw Parts List Miter Gauge Assembly PWBS-14 Band Saw Parts List Table & Trunnion Assembly PWBS-14 Band Saw Table & Trunnion Assembly PWBS-14 Band Saw Parts List Blade Tension Lever PWBS-14 Band Saw Blade Tension Lever PWBS-14 Band Saw Parts List Closed Stand Assembly PWBS-14 Band Saw Closed Stand Assembly PWBS-14 Band Saw Parts List Fence & Rail Assembly PWBS-14 Band Saw Fence & Rail Assembly PWBS-14 Band Saw WMH Tool Group
Related manuals
Manual 40 pages 2.14 Kb