TROUBLE-SHOOTING (PWBS-14 Band Saw)
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
| ||
|
|
|
|
|
| |
| Saw stops or will not start | 1. Saw unplugged | 1. | Check plug connections |
| |
|
| 2. Fuse blown or circuit breaker tripped | 2. | Replace fuse or reset circuit |
| |
|
|
|
|
| breaker |
|
|
| 3. | Cord damaged | 3. | Replace cord |
|
| Does not make accurate | 1. | Stop not adjusted correctly | 1. | Check blade with square and |
|
| 45 deg. or 90 deg. cuts |
|
|
| adjust stop |
|
|
| 2. | Angle pointer not set accurately | 2. | Check blade with square and |
|
|
|
|
|
| adjust pointer |
|
|
| 3. | Miter gauge out of adjustment | 3. | Adjust miter gauge |
|
| Blade wanders during cut | 1. | Fence not aligned with blade | 1. | Check and adjust fence |
|
|
| 2. | Warped wood | 2. | Select another piece of wood |
|
|
| 3. | Excessive feed rate | 3. | Reduce feed rate |
|
|
| 4. | Incorrect blade for cut | 4. | Change blade to correct type |
|
|
| 5. | Blade tension not set properly | 5. | Set blade tension according to |
|
|
|
|
|
| blade size |
|
|
| 6. | Guides not set properly | 6. | Adjust guides |
|
| Saw makes unsatisfactory | 1. | Dull blade | 1. | Replace blade |
|
| cuts | 2. | Blade mounted wrong | 2. | Teeth should point down |
|
|
| 3. | Gum or pitch on blade | 3. | Remove blade and clean |
|
|
| 4. | Incorrect blade for cut | 4. | Change blade to correct type |
|
|
| 5. | Gum or pitch on table | 5. | Clean table |
|
| Blade does not come up | 1. | Extension cord too light or too long | 1. | Replace with adequate size and |
|
| to speed |
|
|
| length cord |
|
|
| 2. | Low shop voltage | 2. | Contact your local electric |
|
|
|
|
|
| company |
|
| Saw vibrates excessively | 1. | Stand on uneven floor | 1. | Reposition on flat, level |
|
|
|
|
|
| surface |
|
|
| 2. | Bad | 2. | Replace |
|
|
| 3. | Motor mount is loose | 3. | Tighten motor mount hardware |
|
|
| 4. | Loose hardware | 4. | Tighten hardware |
|
24