Powermatic PWBS14 operating instructions Tilting the Table, Adjusting 90 Table Stop

14.For resawing operations attach the resaw guide (Fig. 20) to the fence with the knob. There is a slotted hole in the fence that will accomodate the resaw kit. Position the resaw guide so that it is centered with the front edge of the saw blade. The resaw guide will give you a taller, single-point contact surface during resawing.

Tilting the Table

WARNING

Unplug the￿machine from the power

source before making any repair or adjustment! Failure to comply may cause serious injury!

1. Loosen the two lock knobs (A, Fig. 21).

2. Tilt table up to 45 degrees to the right. The angle is indicated on the trunnion scale.

3. Tighten the two lock knobs (A, Fig. 21).

Adjusting 90° Table Stop

1.Disconnect machine from power source.

2.Loosen lock knobs (A, Fig. 21) and tilt table to the left until it rests against the table stop (B, Fig. 21).

3.Use a square placed on the table and against the blade, as pictured in Fig. 22, to see if the table is 90 degrees to the blade.

4.If an adjustment is necessary, tilt the table out of the way and tighten the lock knobs (A, Fig. 21).

19