How to Program a Radio Shack Scanner: Setup and Features for Models 20-136 PRO-136

Scanner Setup

2.The hour digits ﬂash. Press T or S or press the number keys to enter the hour. Then press ENT/PROGRAM to set.

3.The minutes digits ﬂash. Press T or S or press the number keys to enter the minutes. Press ENT/PROGRAM to set.

Note: When setting the clock minutes, the seconds digits are reset to 00 to enable accurate time adjustment.

4.AM/PM ﬂashes. Press T or S to select AM or PM. Press ENT/PROGRAM to set.

5.To save your selection, slide the Clock Switch to Clock.

6.To set the alarm, slide the Clock Switch to Alarm Set and repeat steps 2-5.

Alarm Function

•Slide the Alarm Switch to Tone, if you want the alarm to sound a tone at the set time.

•Slide the Alarm Switch to Radio if you want the alarm to sound with the channel that was previously selected in Scan Mode. The radio alarm will only sound in Standby Mode.

•To silence the alarm, slide the Alarm Switch to Off. If you do not turn off the alarm, it will sound for 20 minutes then reset to alert you again the following day.

Programming Frequencies into Channels

Before the scanner can begin to scan, you must program a frequency into at least one channel.

To locate and store speciﬁc frequencies into channels for later use:

1.From Scan Mode, press SCAN/MAN to stop scanning.

2.Press ENT/PROGRAM to put the scanner in programming mode. PGM appears.

3.Use the number keys to enter both the channel storage bank and the channel number you want to assign to a frequency.

4.Press SCAN/MAN.