Pride Mobility SilverStar manual House Docking Station Charging, Follow these steps to charge

Page 11

Basic Operation Instructions

11

In House Docking Station

 

Charging

 

Follow these steps to charge the

BATTERY

battery pack with the In House

PACK

Docking Station:

 

1. Remove the battery pack from

BATTERY

the battery pack base.

CHARGER

2. Place the charger base near a

 

standard electrical outlet. See

 

figure 4.

 

3. Connect the charger harness to

CHARGER

the power lead extending from

BASE

the charger base, then plug the

 

3-pronged plug into the electri-

Figure 4. Battery Charging Base

cal outlet.

 

4.Place the battery pack onto the charger base.

5.Monitor the LEDs on the side of the charger base for charging sta- tus. See figure 8.

www.silverstarmobility.com

Removable Battery Pack

Image 11
Contents Removable Battery Pack Safety Guidelines Table of Contents Label Information Product Safety SymbolsLabel Information Introduction Battery Pack Installation to Exterior Lift InstallationUre Battery Pack Installation to Backpacker Series LiftsHousing. See figure Battery Pack Installation to SilverBoomHarness Connections Battery Charging Docking Station Battery pack with the In HouseHouse Docking Station Charging Follow these steps to chargeIt is recommended that Chargerbeconnectedtoacontinuously Backpacker Series/SilverBoom Battery Pack ChargingTo charge the mobility product’s batteries Mobility Product Battery ChargingBattery Charger LEDs To remove the battery from the pack see figure Battery ReplacementTo change the fuse in the auxiliary outlet plug TroubleshootingWhat if the battery will not charge? Event the battery pack’s fuse should cease to work LED Condition Charger SpecificationsBasic Operation Instructions Basic Operation Instructions INFMANU3630