Basic Operation Instructions | 13 |
Mobility Product Battery Charging
The battery pack’s internal charger is capable of charging the batteries of the mobility product you are transporting. This option is only available for Backpacker Series and SilverBoom lifts. The internal battery pack is also capable of charging a
PLUG INTO |
AUXILIARY |
OUTLET |
Figure 6. Charging A Mobility Device
To charge the mobility product’s batteries:
1.Ensure the battery pack is plugged into the vehicle’s auxil- iary outlet.
2.Plug the charger cord into the
PIN 1 = BATTERY +
PIN 2 / PIN 3 JUMPERED =
INHIBIT HIGH
PIN 3 = BATTERY -
Figure 7. Pin Configuration
BATTERY CHARGER LEDs
The LEDs on the side of the battery pack (see figure 8) indicate charging status. (See the table below.) Each battery has its own LED. The right LED indicates the charging status of the
24-VOLT LED
Figure 8. Battery Pack LEDs
LED | CONDITION |
Fast flashing LED | Indicates charge verification (do batteries need charging?) |
Slow flashing LED | Indicates the battery is charging |
LED is solid | Indicates the battery is charged above 95% |
Both LEDs are off | Indicates the charger is off |
Alternately flashing LEDs | Indicates a fault |
Both LEDs alternately flash 3 times | Indicates the batteries are not connected |
www.silverstarmobility.com | Removable Battery Pack |