Basic Operation Instructions | 9 |
PROHIBITED! Do not mount the battery pack in an area where it will be affected by moisture or dirt.
Follow these steps to install the battery pack to the SilverBoom:
1.Determine a location to mount the battery pack to the vehicle. See figure 3.
2.Inspect the undercarriage of the vehicle (where the battery pack is lo- cated) for obstructions that may hinder the installation of the mounting screws that secure the base to the vehicle (e.g., electrical wiring, the gas tank, bumper mounts, or exhaust pipes).
3.Mark the location of the mounting holes, then drill pilot holes, which should be smaller than the diameter of the mounting screws.
4.Secure the case to the vehicle using the supplied hardware.
5.Plug the harness from the battery pack into the mating harness extending from the lift. See figure 3A.
WARNING! A battery pack that is not secured properly to the vehicle can become a hazard while driving.
MOUNTING SCREWS |
Figure 3. Battery Pack Installation
BATTERY |
HARNESS |
Figure 3A. Harness Connections
www.silverstarmobility.com | Removable Battery Pack |