Deep Conditioning Mode

This mode can rescue rechargeable batteries damaged by memory effect. It will automatically discharge and recharge the batteries in both compartments three times.

1.Insert batteries into either one or both of the compartments. Please note that this mode will automatically discharge and recharge the batteries in both compartments three times.

2.Press and hold the yellow DISCHARGE button until the READY LEDs begin to flash and the charger makes “beep” sound. Release the button immediately.

3.The LEDs light up as in Discharge and Charge Mode. The only difference is the flashing of the READY LEDs. During the 1st cycle, the READY LEDs flash three times, stop, and repeat until the cycle is completed.

4.During the 2nd cycle, the READY LEDs flash twice, stop, and repeat until the cycle is completed.

5.During the final cycle, the READY LEDs flash once, stop, and repeat until the whole deep conditioning mode is completed.

6.When this mode is completed, the READY LEDs blinks, and the CHARGE and DISCHARGE LEDs all go off. The batteries are now ready for use.

Note: Press the DISCHARGE button to cancel Deep Conditioning Mode and switch back to Charge Mode at any time if desired.

Note: The deep conditioning process from beginning to end may take up to 20 - 40 hours. Please see the charge and discharge equations on page 4 to estimate approximate time.

- 7 -