ASSEMBLY INSTRUCTIONS/OPERATION
9)Couple the NEMA
10)Grasp the operator handle with firm gripping. When starting the electric motor, apply a down force directly to the operator handle to help reduce the amount of static machine weight against the work surface. The blade or ceramic tile ripper attachment should remain in contact with the surface. Turn the ON/OFF switch to the ON position. Reduce the amount of applied down force on the operator handle as the electric motor attains its operational speed.
FIGURE 22
11)The FLOOR COVERING SCRAPER is not equipped with a centrifugal clutch assembly. The electric motor is directly coupled to the exciter plate. The exciter plate will begin to move when the electric motor starts.
DANGER
AS SOON AS THE ELECTRIC MOTOR HAS STARTED, THE OPERATOR MUST BE IN A POSITION TO ASSUME DIRECT AND FULL CONTROL OF THE FLOOR COVERING SCRAPER. FAILURE TO ASSUME DIRECT AND FULL CONTROL CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.
12)The FLOOR COVERING SCRAPER is stopped by moving the ON/OFF switch located on the operator handle to the OFF position. For safety considerations, it is also recommended that the extension cord be
disconnected from both the FLOOR COVERING SCRAPER and power source receptacle whenever the FLOOR COVERING SCRAPER is not in use on the job site.
DANGER
IF THE FLOOR COVERING SCRAPER IS EQUIPPED WITH A TOGGLE TYPE ON/OFF SWITCH THE MOTOR CAN RESTART IF THE ON/OFF SWITCH IS NOT MOVED TO THE OFF POSITION WHEN THE POWER SOURCE LOOSES POWER AND THEN BECOMES
13)If the FLOOR COVERING SCRAPER is equipped with a magnetic start (push button) type ON/OFF switch, the motor will not restart if the power source looses power and then becomes
CAUTION
If the FLOOR COVERING SCRAPER and/or an individual component/accessory does not appear to be functioning properly, STOP and do not further operate the FLOOR COVERING SCRAPER until the proper corrective action has been completed. If there are any questions regarding the proper operation of the FLOOR COVERING SCRAPER, contact the Customer Service Department BEFORE further utilization. There is no charge for this service.
OPERATING THE FLOOR COVERING SCRAPER ON THE JOBSITE.
DANGER
THE COVERINGS REMOVAL PROCESS CAN PRODUCE EXCESSIVE NOISE, VIBRATION AND FLYING DEBRIS. ALL OPERATORS AND WORK PERSONNEL IN THE VICINITY OF THE FLOOR
COVERING SCRAPER MUST WEAR APPROPRIATE SAFETY EYE WEAR AND HEARING PROTECTION DEVICES. OTHER SAFETY APPAREL AND/OR PROCEDURES, DEEMED NECESSARY BY SUPERVISORY PERSONNEL MUST ALSO BE WORN AND/OR
PRACTICED BY ALL APPROPRIATE PERSONNEL.
| OPERATION AND PARTS MANUAL REV #4 (05/28/09) | PAGE 23 |
|
|
|