AR13HA-R RIDE-ON ROLLER — ROLLER COMPONENTS
40
| 42 |
|
|
| 41 |
| 38 |
|
|
| |
|
|
| 37 |
| 35 | 36 |
|
|
|
| 30 |
| 29 |
|
|
33 | 34 |
| 26 |
|
| ||
| 28 | 27 | 39 |
|
|
32
31
Figure 5. Roller Components 2
Figure 5 shows the location of additional components for the AR13HA-R compaction roller. The function of each component or control is described below:
26.Front Sprinkler System – A gravity feed spray bar is provided for the wetting the roll for asphalt pavement.
27.Hydraulic Manifold – Aluminum block that controls the flow of hydraulic pressure to the various hydraulic motors and other components required to control the roller.
28.Hydraulic Oil Filter – Filters return oil from the front and rear hydrostatic motors.
29.Accessory Relay – Provides the +12VDC necessary to run the roller's electrical accessories.
30.Hydraulic Pump – This unit incorporates an axial variable displacement hydraulic piston pump.
31.Front
32.Hydraulic Motor – This hydraulic motor controls the rotation of the vibratory system.
33.Bunjee Latch – Pull this rubber latch upward and back to gain access to the engine/pump compartment.There is one rubber latch located on each side of the unit.
34.Steering Cylinder – Controls direction of roller.
35.Engine – This unit incorporates a HONDA
36.Hydraulic Fluid Filler Port – Remove this cap to add hydraulic fluid. Fill with type ISO 46
37.Compartment Hood – Houses the engine, hydraulic manifold, accessory relay, hydraulic oil filter, hoses, and hydraulic pump. To lift the compartment hood, release the rubber bunjee latches located on each side of the hood.
38.Compartment Hood Lift Point – Place hand here then lift upwards to lift compartment hood.
39.Hydraulic Motor – This hydraulic motor drives the roller during operation.
40.Rear Drum Zerk Grease Fitting – Grease this fitting
41.Articulation Zerk Grease Fitting – Grease this fitting once a year. See maintenance section of this manual.
42.Hand Rail – Grab hold of this hand rail when lifting yourself onto the operator's platform.
PAGE 20 —