Vector VEC021STC AIR COMPRESSOR/TIRE Inflator, Tire Inflation or Products with a Valve Stem

Page 11

6.AIR COMPRESSOR/TIRE INFLATOR

IMPORTANT:

Read Instructions Carefully To Avoid Possible Injury Or Property Damage.

The built-in 12 Volt DC air compressor is the ultimate compressor for all vehicles, trailer tires and recreational inflatables. Three different sized nozzles are supplied. Each nozzle will clip on the end of the standard tire valve connector located at the free end of the compressor hose. The compressor nozzles are stored inside the hose hatch. The compressor hose with tire fitting is stored in a retaining channel between the jumper cable channels on the rear of the unit. The ON/OFF Switch is located on the side of the Main Unit near the AC Recharge Port. The compressor can operate long enough to fill up to 3 average sized tires before the battery must be recharged.

The compressor may be used by removing the air hose from the storage hatch and if required, fitting an appropriate nozzle to the air hose. An On/Off switch located on the side of the unit controls the power to the compressor and the gauge light. Refer to Figures 3 for locations of compressor hose, nozzle storage hatch and hose. Return hose to the storage compartment after use.

COMPRESSOR

HOSE, NOZZLE

STORAGE HATCH

AND HOSE

ADAPTER

NOZZLES

6.1WARNINGS FOR COMPRESSOR USE

The compressor is capable of inflating up to 260 pounds per square inch (PSI) pressure. To avoid over-inflation, carefully follow instructions on articles to be inflated. Never exceed recommended pressures. Bursting articles can cause serious injury. Always check pressure with the pressure gauge. Never leave compressor unattended while in use. Allow unit to cool after 10 minutes of continuous operation.

6.2TIRE INFLATION OR PRODUCTS WITH A VALVE STEM

1.Place connector (chuck) on valve stem.

2.Push connector toward valve stem and close thumb latch.

3.Make sure connector is pushed on to valve stem as far as possible before closing thumb latch.

4.Check pressure with the pressure gauge (Refer to paragraph 6.5).

5.When desired pressure is reached, open thumb latch and remove connector from valve stem.

6.Turn OFF Compressor Power Switch.

7.Store compressor hose and tire fitting in storage compartment.

11

Image 11
Contents JUMP-STARTER, AIR Compressor and 12 Volt DC Power Supply First AID Safety InformationPage Contents Introduction Front View Additional FeaturesUsing the Power on Board AS a JUMP-START System EASY, STEP-BY-STEP JUMP-STARTING Instructions System Negative Battery Terminal is Connected To Chassis120 Volt AC Charging Make Sure ALL Switches are Turned OFF During RechargingCHARGING/RECHARGING 12 Volt DC Charging Operation AS a 12 Volt Portable Power SupplyEstimated Battery Life EMERGENCY/WORK LightTire Inflation or Products with a Valve Stem AIR COMPRESSOR/TIRE InflatorTypical Inflation Times Replacement PartsInflating Other Articles Without Valve Stem Battery Disposal SpecificationsBulb Replacement Battery ReplacementTWO Year Limited Warranty Program Page REV.DK051903