Vector VEC021STC owner manual Charging/Recharging, Volt AC Charging

Page 9

FIRST AID:

SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention

EYES: If battery acid comes in contact with eyes, flush eyes immediately for a minimum of 15 minutes and SEEK IMMEDIATE MEDICAL ATTENTION

3.CHARGING/RECHARGING

For maximum battery life, we recommend the POWER ON BOARD® system is kept fully charged at all time. If the battery is allowed to remain in a discharged state, battery life will be shortened.

NOTE: Recharging battery after each use will prolong battery life; frequent discharges between recharges will reduce battery life

IMPORTANT:

MAKE SURE ALL SWITCHES ARE TURNED OFF DURING RECHARGING

Charge unit for full 24 hours using AC method, prior to first use

Recharge unit fully after each use

Recharge unit every two months, when it has not been used

3.1 120 VOLT AC CHARGING

1.Simply plug the AC plug of the AC/DC adapter/charger into any standard 120 volt AC wall outlet.

2.Plug the barrel connector attached to the AC/DC adapter into the small barrel receptacle on the jump-starter that is marked recharge port.

3.Charge this device for at least 14-16 hours or until the green FULL indicator lights.

4.When charging is completed and the FULL light lights, remove the AC/DC charger plug and store in a safe place.

NOTE:

The unit cannot be overcharged using the AC method. The POWER ON BOARD® system also comes with a DC/DC charging adapter for recharging the unit from a 12 volt DC cigarette lighter or accessory socket in a vehicle or boat .

This recharging method will NOT recharge the unit as effectively as recharging from a 120 volt AC outlet. The 12 Volt DC recharging procedure is recommended only when it is necessary, as continued use of the 12 Volt DC recharging procedure may shorten the battery system’s life .

If unit is fully discharged, it is recommended that the vehicle being used for recharging be left running while the unit is being charged via the 12 Volt DC method.

CAUTION:

Do not recharge for more than 3-4 hours maximum using 12 Volt DC method.

9

Image 9
Contents JUMP-STARTER, AIR Compressor and 12 Volt DC Power Supply First AID Safety InformationPage Contents Introduction Front View Additional FeaturesUsing the Power on Board AS a JUMP-START System EASY, STEP-BY-STEP JUMP-STARTING Instructions System Negative Battery Terminal is Connected To ChassisMake Sure ALL Switches are Turned OFF During Recharging CHARGING/RECHARGING120 Volt AC Charging Estimated Battery Life Operation AS a 12 Volt Portable Power SupplyEMERGENCY/WORK Light 12 Volt DC ChargingTire Inflation or Products with a Valve Stem AIR COMPRESSOR/TIRE InflatorReplacement Parts Inflating Other Articles Without Valve StemTypical Inflation Times Bulb Replacement SpecificationsBattery Replacement Battery DisposalTWO Year Limited Warranty Program Page REV.DK051903