WARNINGS:
1.There is risk of dust or dirt projectiles being released if the compressor hose or nozzles are not clean when the compressor is turned on.
2.Wearing protective goggles while operating this compressor can protect eyes from flying particles of dust and dirt. Failure to follow instructions ay cause property damage, and/or personal injury.
3.Keep out of reach of children.
4.POWERING THE COMPRESSOR
The compressor can be powered either from a supplied battery pack or from a supplied DC Power Adapter.
4.1 POWERING FROM THE BATTERY PACK
The supplied battery pack powers the compressor for short duration, cordless operation. The Battery Pack should be fully charged initially before use (see section 5 for charging instructions.)
To connect the charged battery pack to the compressor, align the battery pack so that the battery release buttons snap onto the compressor. The battery pack fits only one way to ensure correct polarity of the contacts. To remove the Battery Pack, press the Battery Pack release buttons and the battery pack will release from the compressor.
4.2 DC POWER ADAPTER USE
The DC power adapter can power the compressor for longer operation from an external 12 volt power source.
The DC Power Adapter has a fused DC plug and connecting cord stored inside the DC Power Adapter. To use the DC Power Adapter, first remove the DC plug from it’s storage in the adapter. Deploy the cord from storage, and connect the DC Power Adapter to the compressor. Make sure it snaps into position. Connect the DC plug to a 12 Volt DC source. To remove the DC Power Adapter, press it’s release buttons and the Adapter will release from the compressor. Put the DC Plug and cord in the Adapter for storage after use.
FIGURE 3 | CONTACT | |||
|
| FUSED DC |
| |
7 |
| PLUG |
| RELEASE BUTTON |
|
| |||
|
|
| ||
|
|
|
| |
|
|
|
|
|
|
|
|
|
|