Kompernass PKGS1450 manual Introduction / Safety, Replaceable parts, Technical information

Page 5

LReplaceable parts

You can replace the following parts yourself.

When you do this always observe the relevant ope- rating instructions and safety advice.

-Sawdust collection bag (a)

-Laminate cutting attachment {

-Stop plate q

-Saw blade

Have any other maintenance and repair tasks car- ried out by our service centre or an accredited elec- trical equipment repair centre.

LTechnical information

Nominal output:

1450 W

Nominal voltage:

230 V ~ 50 Hz

Nominal speed:

n0 1800 - 4500 min-1

Circumferential speed:

24 m / s – 55 m / s

Weight:

14.5 kg

Protection class:

II / &

Sound pressure level:

Lp = 95.5 dB (A)

Sound power level:

Lw = 108.5 dB (A)

Vibration:

2.5 m / s2

Saw blade for wood

 

(supplied installed):

250 x 30 x 1.8 mm,

 

36 HM - teeth (3.0 mm)

Universal saw blade:

250 x 30 x 2.35 mm,

 

80 HM - teeth (3.2 mm)

Cutting capacity:

 

Cutting width:

max. 140 mm (without

 

laminate cutting attachment)

 

max. 200 mm (with laminate

 

cutting attachment)

Cutting depth:

max. 65 mm

Introduction / Safety

LSafety

Safety advice relating specifically to this saw

JEnsure that the device is always used in accord- ance with the advice in these operating instruc- tions and only by persons over 18 years of age.

JKeep children away from the device.

Store the device indoors in an enclosed, dry place where it cannot be reached

by children.

JIn addition, you must also read the advice in the accompanying booklet containing safety advice before using the device for the first time.

JCheck that all moving parts on the tool are working properly, can move freely and are not damaged. All parts must be correctly attached and fulfil all the requirements necessary to allow the electrical tool to operate properly.

JCarry out the following before each use:

-check the saw for damaged parts or safety equipment and if necessary have them replaced by an electrician.

-check the saw blade for quality / condition, sharpness, cleanliness and free movement.

-check that the saw blade is properly attached and does not wobble. Attach the saw blade by placing the locking spanner (e) on the ou- ter flange u and tightening the screw (for attaching the saw blade) y counter-clock- wise.

To avoid danger to life from electric shock:

JDo not operate the device if the mains lead or mains plug is damaged.

Caution! A damaged mains lead presents a serious danger to life from electric shock. The service centre for your country is shown in the guarantee documentation.

JHave repairs carried out only by an electrician or the relevant service centre.

GB/IE 7

Image 5
Contents Chop Mitre saw Operating and safety instructionsPage Safety ContentCleaning OperationIntroduction Safety advice relating specifically to this saw Introduction / SafetyReplaceable parts Technical informationTo work safely SafetyOperation Assembly Safety / OperationChecking and setting your saw Parallel saw bladeOperation Connecting a dust extraction deviceSetting the speed Switching the laser on and off and adjusting itTransporting the machine Mitre cuts turning the saw tableMaking a combination cut Inclined cuts inclining the saw motor unitChanging a saw blade Tips and tricksCleaning Maintenance and cleaning Cleaning / Disposal / InformationInformation Service DisposalPage