Mercedes-Benz W211, R230 manual Deactivation

Page 39

Deactivation

SBC must be deactivated with SDS before any work is performed on the system. This will prevent the pre-drive check from being automatically performed which could cause injury.

Deactivating the system will:

• empty the pressure reservoir

(a lower pressure with no volume may be retained)

• prevent the charge pump from operating

•Note: the warning buzzer is deactivated when accessing SBC with the SDS.

Image 39

Contents SBC Sensotronic Brake ControlObjectives Contents SBC Incorporates these Functions Advantages of SBC Advantages of SBC Advantages of SBC Driving with SBC Wake-Up Driving with SBC Pre-Drive Check PDC Driving with SBC Delayed Off Function Page Page SBC Components SBC W211 System OverviewR230 System Overview X11/4 Diagnosis Connection Brake Operating Unit BOU Brake Operating Unit Master Cylinder Fluid Reservoir Cover Pedal Value Sensor B37/1 Fluid reservoir BOU Tandem Master CylinderNormal Braking Light Pressure Normal Braking Increased Pressure Normal Braking Strongest Feedback Emergency Operation Traction System Hydraulic Unit A7/3 Traction System Hydraulic Unit A7/3 Page Emergency Operation Circuit Brake Pressure Supply Three Pressure Stages Pressure Apply Rear Wheels Pressure Apply Front Wheels Pressure Apply All Wheels Pressure Hold All Wheels Pressure Reduction All Wheels Temperature Compensation Deactivation Deactivation Pressure at A7/3b2 System Activation System Activation Activation Left Front Activation Right Front Activation Right Rear Activation Left Rear Activation Recharge Proper system bleeding is critical Follow directions in SDS Bleeding the Brake SystemEquipment Required Connect equipment and follow steps in SDS Acronym List Appendix