User’sManual - page 3
PreparingNew Discs with Rough Spots
Anew disc may have rough edges on its
insideand outside edges. If a disc with
roughedges is used, the proper setting
willnot be performed and the player will
notplay the disc. Therefore, remove the
roughedges in advance by using a
ballpointpen or pencil as shown on the
right.To remove the rough edges, press
theside of the pen or pencil against the
insideand outside edges of the disc.
Roughspots
on
outsideedge
Ballpoint pen
orpencil
Roughspots on inside edge
Notes:
-Choose the mounting location where the unit
willnot distract the driver.
-Before the installing of the unit, connect the
wiringtemporarily and make sure it is all
connectedup properly and the unit and the
systemworks.
-Use only the parts included with the unit to
ensureproper installation. The use of
unauthorizedparts can cause malfunctions.
-Consult with your nearest dealer if
installationrequires the drilling of holes or
othermodifications of the vehicle.
-Install the unit where it does not get in the
driver'sway and cannot injure the passenger if
thereis a sudden stop, like an emergency
stop.
-If installation angel exceeds 30°from
horizontal,the unit may not perform properly.
-Avoid installing the unit where it will be
subjectto high temperature, such as from
directsunlight, or from hot air, from the
heater,or where it would be subject to
dust,dirt or excessive vibration.
Installation
Labelside
up
Donot
bend
Donottouch
theunderside
ofthedisc
Wipethedisc from
centertowardthe
outsideedge