WARNINGS AND SAFETY RULES
1.Wear proper clothing. Always use
2.Wear proper breathing protection. Remember that a “dust mask” is not a breathing respirator. Use a respirator that uses charcoal filters for the best protection.
3.Keep work area clean and well lighted. A dim and/or cluttered work area invites personal injury.
4.Keep children and pets away from work areas. Children can be a distraction and should be supervised by an adult when near the work area. Never allow children to play with this product even if it is turned off.
5.Store idle tools properly. Keep this cutoff tool out of the reach of children and untrained operators.
6.Do not use the cutoff tool if under the influence of alcohol or prescription drugs. Doing so may cause damage to the tool, or personal injury. Do not use this or any tool if you are tired. Use common sense at all times.
7.Check for damaged parts. Before using this cutoff tool, carefully check for any parts that may be missing or damaged and any other conditions that may affect the operation of this tool. Replace or repair damaged and worn parts immediately using only qualified repair facility.
8.Always use the proper tools. This cutoff tool was designed for a specific task. Do not alter this tool, or use it for a purpose for which it was not intended.
9.Be careful when connecting/disconnecting air supply. It is recommended to use
10.Use compressed air only. Clean, dry regulated compressed air at 90 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.
11.Always disconnect air supply when this tool is not being used.
12.Take caution as some woods contain preservatives such as copper chromium arsenate (CCA) which can be toxic. When cutting these materials, extra care should be taken to avoid inhalation and minimize skin contact.
13.3" Cutting wheel: Only use a standard 3" cutting disc (rated at 18,000 RPM or greater) with this air high speed cutter. Never use any other type of disc, blade or cutter on this air tool. This may cause the tool to operate incorrectly.
NOTE: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors that cannot be built into this product but must be supplied by the operator.
NOTE: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
Page: 3 of 7