WARNING! Position the high speed cutoff tool so that the attached guard is in position
between you and the workpiece to protect you from flying debris.
WARNING! Guard must always be attached to high speed cutoff tool.
1.Check the cutting wheel for wear. Replace if necessary.
2.Set the compressor to 90 PSI. Do not exceed 90 PSI.
3.Connect the cutoff tool to the air hose as explained.
4.Using both hands to grip the cutoff tool, gently squeeze down on the trigger. Allow the tool to run for a few seconds before approaching the workpiece.
5.Let the cutoff tool do the work. Do not apply force on the workpiece.
6.When finished, release the trigger.
7.Disconnect the air hose.
8.Gently squeeze down on the trigger to release any air that might still remain in the tool.
MAINTENANCE
WARNING! Always disconnect the air supply before attempting any maintenance.
After disconnecting the air supply, squeeze the trigger to make sure no air remains in the unit.
1.After each use, wipe down the cutoff tool with a
2.Make sure the air inlet is clean of dirt, grease, or debis.
3.Check the condition of the cutting wheel before each use. Replace if necessary.
Page: 5 of 7