1.Attach appropriate nail guide or hammer attachment.
2.Orient nail (A) Fig. 29 with point down and and insert into the nail guide (B).
3.Position point of nail (A) Fig. 30 in the desired location and push down on the tool. The tool will began cycling and driving the fastener.
NOTE: Be sure to maintain constant hand pressure in line with the nail until the nail is fully seated. Experiment with the air pressure setting to determine the lowest setting that will consistently perform the job at hand. Air pressure in excess of that required can cause premature wear and/or damage to the tool.
4.During each tool cycle, air will exhaust out of ports (A) Fig. 31.
5.When using hammer attachment, hold fastener by hand until driven deep enough to stay in place. Remove hand to complete driving fastener.
B
A
Fig. 29
A
Fig. 30
A
Fig. 31
MAINTENANCE
CLEAN AND INSPECT DAILY
WARNING: Disconnect tool from air supply before cleaning and inspection. Correct all problems before placing the tool back in use.
Wipe tool clean and inspect for wear or damage. Use
Keep all screws as well as nail guide bushing tight. A 4mm hex wrench and 24 x 30mm open end wrenches are provided. Loose screws and bushings can cause personal injury or damage tool.
If tool is used without an
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due to wear from normal use. These operations should ONLY be performed by either an AUTHORIZED
10