DANGER: All air line components (hoses, connectors, filters, regulators, etc.) must have a minimum working pressure rating of at least 150 PSI (10.3 BAR) or 150% of maximum system potential, whichever is greater.
•Do not connect tool to pressure which potentially exceeds 200 PSI (13.7 BAR).
•Only connect tool to air supply hose with a coupling that automatically removes all pressure from the tool when the coupling is disconnected.
•Disconnect tool from air supply before performing maintenance, clearing a jammed fastener, leaving work area, moving tool to another location, or handing the tool to another person.
ASSEMBLY
ATTACHMENT INSTALLATION AND REMOVAL
MAGNETIC NAIL GUIDE ASSEMBLY
1.
WARNING: Disconnect tool from air supply.
2.The magnetic nail guide (A) Fig. 14 for driving 6d to 16d common flat head nails comes assembled on the tool. To change attachments proceed as follows;
3.Lay the tool on its cap with nail guide pointing upward. Loosen and remove the magnetic nail guide bushing (B) Fig. 14 using the 24mm open end wrench (C) supplied. NOTE: Always place removed attachments in the carrying case for safe storage.
4.Lift the magnetic nail guide (A) Fig. 15 and bushing (B) off of the driver blade and return them to the carrying case. To reinstall magnetic nail guide reverse the procedure.
AC
B
Fig. 14
5.Depending on the application, fastener depth can be adjusted by air pressure or by adding/removing wave washers (D) Fig. 16 that are installed over driver blade (E). For the hammer attachment installation, spring (C) Fig. 16, driver guide (F) and three wave washers (D) must all be removed.
Fig. 16
F
C
A B
Fig. 15
E
6