PYLE Audio 314 To Adjust Depth of CUT, To Adjust for Bevel Cuts, To Attach the Base Insert

TO ADJUST DEPTH OF CUT

DISCONNECT TOOL FROM POWER SOURCE.

Loosen the depth adjusting knob (A)
Fig. 1, and raise or lower the saw
housing until the blade extends the
desired distance below the base. For
best results, the blade should barely
protrude through the workpiece. Firmly
tighten the knob to hold the saw in
position.	Fig. 1

A

TO ADJUST FOR BEVEL CUTS

DISCONNECT TOOL FROM POWER SOURCE.

Loosen the front (A) Fig. 2 and rear (B) Fig. 2 angle-adjusting knobs. Tilt the saw housing until the desired graduation mark (C) lines up with the indicating line (D) Fig. 3 on the depth adjusting bracket. Firmly tighten the knobs to hold the saw in the selected position.

B

A

D

C

Fig. 2

Fig. 3

TO ATTACH THE BASE INSERT

The base insert is used to reduce chipping and splintering of the top fibers of plywood and paneling when used in conjunction with a fine tooth blade. When the base insert is used, it is not necessary to have the good or finished side of the work down during the cutting operation.

NOTE: Do not use this insert when making bevel cuts.

11