Grizzly G0561 owner manual Vertical Assembly, To assemble the bandsaw for vertical cut- ting

Vertical Assembly

The Model G0561 can easily be set up for vertical cutting operations.

Components and Hardware Needed:	Qty
Vertical Work Table	1
Table Bracket	1
Flat Head Screw 1⁄4"-20 x 3⁄8"	1
Hex Nut 1⁄4"-20	1

To assemble the bandsaw for vertical cut- ting:

1.Remove the two screws and blade guide cover as shown in Figure 15.

Figure 15. Removing blade guide cover.

2.Install the vertical work table and replace the two screws removed in Step 1.

3.Install the table bracket shown in Figure 16 with the bolt already in the casting.

Bolt Already

in Casting

Figure 16. Table and bracket installed.

-20-

4.Set a square to the side of the blade, as shown in Figure 17, and adjust the table bracket to square the table to the blade.

Figure 17. Squaring table to blade.

5.Place a level on the table, as shown in Figure 18, and turn the adjustment bolt shown in Figure 19 until the table is level.

Figure 18. Adjusting table level.

Figure 19. Adjustment bolt.

6.Close the feed ON/OFF valve to lock the bow in position (see Figure 20).

G0561 7" x 12" Metal-Cutting Bandsaw