Wheels & Leveling
Feet
The wheels may be installed to make it easier to move the G0561 bandsaw.
Components and Hardware Needed: | Qty |
Wheels | 2 |
Axle | 1 |
Cotter Pins 3 x 30mm | 2 |
Leveling Feet with Hex Nuts | 2 |
Flat Washers 10mm | 2 |
To install the wheels and leveling feet: |
|
1.Slide the axle through the holes in the bottom of the cabinet.
2.Slide the wheels on the axle and secure with the two cotter pins as shown in Figure 7.
Axle
Figure 7. Wheels installed.
3.Screw the threaded portion of the leveling feet, followed by the flat washer and hex nut, into the base of the cabinet as shown in
Figure 8.
4.Adjust the feet to level the bandsaw as need- ed.
Hex Nut & Flat Washer | Leveling Feet |
| |
Figure 8. Leveling feet installed. |
Chip Screen
The chip screen is designed to prevent chips and
Components and Hardware Needed: | Qty |
Chip Screen | 1 |
To install the chip screen:
1.Place the chip screen into the opening shown in Figure 9.
Chip Screen
Figure 9. Chip screen installed.
G0561 7" x 12" |