Assembly
Except for the crank handle and the workpiece support, the Model T10727 has been assembled and adjusted at the factory.
To complete the assembly:
1.thread the handle into the crank arm and tighten with a screwdriver, as shown in Figure 3.
Crank
Handle
Figure 3. Crank handle attached.
2.Attach the workpiece support to the front of the slip roll with the two pre-installed M6-1 x 12 cap screws, as shown in Figure 4.
Workpiece Support
x 2
Figure 4. Workpiece support attached.
Mounting in Vise
The forces exerted on the slip roll during operation are substantial. The slip roll must be firmly secured in a vise (see Figure 5 for an example) that is sol- idly attached to a workbench that will support the weight and dynamic forces of the operation (refer to Page 18 for options from Grizzly).
Make sure you have a vise secured to a work- bench, then mount the slip roll by tightening the vise jaws against the lug provided at the bottom of the slip roll.
Note: Use pieces of cardboard, wood, or padded jaw faces between the vise jaws and the vise lug to prevent damage to the slip roll.
Slip Roll
Lug
Figure 5. Example of Model T10727 secured in
a vise mounted to a workbench.
Make sure the workbench that the slip roll is mounted on is stable and can support the weight of the tool, the workpiece, and the forces exerted during operation.