Grizzly T10727 owner manual Service, Troubleshooting, Symptom Possible Cause Possible Solution

Page 22

SECTION 6: SERVICE

Review the troubleshooting and procedures in this section if a problem develops with your machine. If you need replacement parts or additional help with a procedure, call our Technical Support at (570) 546-9663. Note: Please gather the serial number and manufacture date of your machine before calling.

Troubleshooting

Symptom

Possible Cause

Possible Solution

Slip roll creates

1.

Rollers are not parallel.

1.

Use thickness and radius adjustment knobs to make

cones when trying

 

 

 

sure all rollers are parallel with each other.

to create cylinders.

 

 

 

 

A noticeable

1.

Excessive pressure applied in one spot.

1.

raise upper roller to reduce pressure; create form

crease is formed in

 

 

 

in multiple light passes.

workpiece.

 

 

 

 

Hand crank does

1.

Upper roller too high, gears not meshed.

1.

Use thickness adjustment knobs to lower upper

not turn upper and

 

 

 

roller until gears mesh.

lower rollers.

2.

gears damaged.

2.

replace gears.

 

 

 

 

 

 

Slip roll does not

1.

slip roll capacity exceeded.

1.

Use material within slip roll forming capacity.

properly bend

2.

rear roller not engaged with workpiece.

2.

Use radius adjustment knobs to engage rear roller

material.

 

 

 

with workpiece.

 

 

 

 

 

 

 

 

 

-20-

Model T10727 (Mfg. Since 12/12)

Page 21 Page 23
Image 22
Page 21 Page 23
Contents VISE-MOUNT Slip Roll Page Table of Contents Machine Description Manual Accuracy IntroductionContact Info Specifications IdentificationIllustration Key CCWSafety Safety Instructions for MachineryModel T10727 Mfg. Since 12/12 Additional Safety for Slip Rolls UnpackingInventory SetupNeeded for Setup Description QtySite Considerations CleanupBefore cleaning, gather the following Basic steps for removing rust preventativeTo complete the assembly AssemblyMounting in Vise Operations Basic ControlsFlat Rolling Pinching/Crushing HazardCreating Bends To create a bend in a workpieceCreating Cylinders = π DTo create a cylinder Initial cylinder bend Model T10727 Mfg. Since 12/12Re-inserting workpiece to complete Cylinder Workpiece To use the grooves Bending WireTo remove cylindrical workpieces AccESSORIES Schedule MaintenanceCleaning Protecting LubricationTroubleshooting ServiceSymptom Possible Cause Possible Solution Parts MainLabels & Cosmetics Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAWarranty & Returns Order Hours a DAY
Top Page Image Contents