Table
To attach the table to the bandsaw:
1.Loosen the screw that secures the miter bar to the table (Figure 7). DO NOT remove the screw.
Keyhole
Notch
Figure 7. Loosening the screw that secures the
miter bar to the table.
2.Slide the miter bar keyhole notch (Figure 7) off of the screw loosened in step 1.
3.Loosen and remove the phillips screw in the blade slot of the table (Figure 8).
Figure 8. Phillips screw removed from table.
4.Loosen the hex nuts on the four phillips mounting screws (Figure 9).
-14-
Figure 9. Loosening the mounting screws.
5.Remove the knob bolts that secure the trun- nion to the saw and set the trunnion aside (Figure 10).
Figure 10. The trunnion knob bolts.
6.Remove 2 of the 4 hex nuts from the phillips mounting screws and slide the trunnion onto the bottom of the table (Figure 11).
Figure 11. Sliding the trunnion onto the table.
G8976 3 Wheel 12" Bandsaw
