Grizzly H7583 Jig Setup for a Left- Tilt Table Saw, To set up the jig for a left tilt table saw

Jig Setup for a Left- Tilt Table Saw

In this procedure you will partially dissemble the tenoning jig and reassemble it for use on a left-tilt- ing table saw.

To set up the jig for a left tilt table saw:

1.Insert the jig guide bar into the miter slot in the table-saw table.

2.Loosen the small lock lever and remove the large lock lever (see Figure 5).

Small

Lock

Lever

Set Screw

Large

Lock

Lever

Figure 5. Assembled jig.

3.Loosen the pointer screw, and turn the point- er 90º so the jig assembly and base can be separated (see Figure 6).

Micro

Adjustment

Assembly

Pointer Figure 6. Jig base on a right-tilt table saw.

-10-

4.Use the 3mm hex wrench to loosen the set- screw shown in Figure 5.

5.Slide the micro adjustment assembly out of the jig, and lift the jig assembly from the base as shown in Figure 6.

6.Use the 4mm hex wrench to loosen and remove the two button head screws (Figure 7) that hold the guide bar to the base.

Right-Tilt

Saw Location

Button

Head

Screw

Left-Tilt

Saw

Location

Figure 7. Guide bar locations.

7.Reposition the guide bar to the other set of holes and reinstall the button head screws (see Figure 7).

8.Reassemble the jig in reverse order.

9.Go to Page 11, and perform the Guide Bar Adjustment.

H7583 Tenoning Jig