Grizzly H7583 Back Stop Adjustment, To adjust the back stop, do these steps Unplug the table saw

10.Rotate the micro-adjustment knob until the major adjustment sleeve extends 11⁄2" out of the jig, or approximately halfway between the knob and the side of the jig (see Figure 12).

Note: The major adjustment sleeve allows for quick adjustment of the jig positioning. The micro adjustment knob fine tunes the quick adjustment that was made.

Micro-Adjustment

Knob

1 1 ⁄2"

Major Adjustment

Sleeve

Figure 12. Setting major adjustment sleeve.

11.Tighten the small lock lever and use a 3mm hex wrench to turn the positive stop setscrew inward until it stops (see Figure 10).

Note: The positive stop prevents the work support plate from sliding into the saw blade.

12.Tighten the jam nut and make sure the work support plate stops an 1⁄8" away from the edge of the saw blade.

13.Loosen the pointer screw and reposition the pointer to “0” on the scale.

Back Stop

Adjustment

In this procedure you will adjust the back stop perpendicular to the table. Then set the positive stop so the back stop can be returned to the per- pendicular position after angle cutting.

To adjust the back stop, do these steps:

1.Unplug the table saw!

2.Place the jig into the miter slot. Position a machinist’s square against the back stop as shown in Figure 13.

Lock	Back
Lever
	Stop

Jam

Nut and

Positive

Stop

Figure 13. Machinist’s square location.

3.Loosen the lock lever. Position the back stop perpendicular to the table, and tighten the lock lever.

4.Loosen the positive stop jam nut with an 8mm wrench. Use a 2.5mm hex wrench to turn the setscrew inward until it stops, and tighten the jam nut.

H7583 Tenoning Jig -13-